Thanks for the replies! I looked into both of the solutions. Sadly none of the worked (or im just a little lost idk)
1. I tried compiling the "hello_usb" example. For some reason this particular example did not compile at all. So i tried the example "hello multicore" because this also uses the USB connection to print a line of text. This, once more, opened no new COM-Port after flashing my Pico2. After that I enabled USB and UART together and hooked up my USB-UART-Converter once more. On the UART-Line the Output was just fine (I linked the picture below), but USB still was no doing anything. this leads me to the conclusion that my UART0 unit, the one that is also connected to the USB port i think, works just fine.
2. I tried looking for a virtual-USB Port but I did no really find what you were refering to, but i also could no enable DTR in HTerm beacause there is not even a open COM-Port from my Pico2.
Still thanks for your help. I hope it is just a silly mistake of mine![:)]( "Smile")
1. I tried compiling the "hello_usb" example. For some reason this particular example did not compile at all. So i tried the example "hello multicore" because this also uses the USB connection to print a line of text. This, once more, opened no new COM-Port after flashing my Pico2. After that I enabled USB and UART together and hooked up my USB-UART-Converter once more. On the UART-Line the Output was just fine (I linked the picture below), but USB still was no doing anything. this leads me to the conclusion that my UART0 unit, the one that is also connected to the USB port i think, works just fine.
2. I tried looking for a virtual-USB Port but I did no really find what you were refering to, but i also could no enable DTR in HTerm beacause there is not even a open COM-Port from my Pico2.
Still thanks for your help. I hope it is just a silly mistake of mine
Statistics: Posted by ni.c00 — Mon Nov 18, 2024 12:10 pm