Troubleshooting • Re: PAL-M or NTSC-J on RPI-5 Composite

Code:

console=serial0,115200 console=tty1 root=PARTUUID=70957c7b-02 rootfstype=ext4 fsck.repair=yes rootwait quiet splash plymouth.ignore-serial-console cfg80211.ieee80211_regdom=GB video=Composite-1:720x576i,tv_mode=PAL-N

Code:

# For more options and information see# http://rptl.io/configtxt# Some settings may impact device functionality. See link above for details# Uncomment some or all of these to enable the optional hardware interfaces#dtparam=i2c_arm=on#dtparam=i2s=on#dtparam=spi=onhdmi_ignore_cec_init=1# Enable audio (loads snd_bcm2835)dtparam=audio=onaudio_pwm_mode=1# Additional overlays and parameters are documented# /boot/firmware/overlays/README# Automatically load overlays for detected camerascamera_auto_detect=1# Automatically load overlays for detected DSI displaysdisplay_auto_detect=1# Automatically load initramfs files, if foundauto_initramfs=1hdmi_ignore_hotplug=1enable_tvout=1# Enable DRM VC4 V3D driverdtoverlay=vc4-kms-v3d-pi5,compositemax_framebuffers=2# Don't have the firmware create an initial video= setting in cmdline.txt.# Use the kernel's default instead.disable_fw_kms_setup=1# Run in 64-bit modearm_64bit=1# Disable compensation for displays with overscandisable_overscan=1# Run as fast as firmware / board allowsarm_boost=1[cm4]# Enable host mode on the 2711 built-in XHCI USB controller.# This line should be removed if the legacy DWC2 controller is required# (e.g. for USB device mode) or if USB support is not required.otg_mode=1

Code:

pi@raspberrypi:~ $ xrandr -display :0.0 --output Composite-1 --set "TV mode" PAL-NX Error of failed request:  BadName (named color or font does not exist)  Major opcode of failed request:  140 (RANDR)  Minor opcode of failed request:  11 (RRQueryOutputProperty)  Serial number of failed request:  22  Current serial number in output stream:  22