Hi! I have a light sensor, XUX0ARCTT16, and no idea how to use it with my Raspberry Pi.
Here's the product information: https://telemecaniquesensors.com/global ... UX0ARCTT16
There's 5 wire screw terminals:
1AC/DC
2AC/DC
3NO
4Relay common
5NC
I'm assuming that terminals 1 & 2 go to the power supply for it (a 24v DC block I have laying around). And then connect 4 to a ground pin on the GPIO, and 5 to an input pin? Are any other resistors or other parts needed? Are the internal pull-up resistors sufficient? I'm a newbie at this sort of stuff, but trying to learn!
The sensor itself will be somewhere between 5 and 10 feet from the Raspberry Pi.
Here's the product information: https://telemecaniquesensors.com/global ... UX0ARCTT16
There's 5 wire screw terminals:
1AC/DC
2AC/DC
3NO
4Relay common
5NC
I'm assuming that terminals 1 & 2 go to the power supply for it (a 24v DC block I have laying around). And then connect 4 to a ground pin on the GPIO, and 5 to an input pin? Are any other resistors or other parts needed? Are the internal pull-up resistors sufficient? I'm a newbie at this sort of stuff, but trying to learn!
The sensor itself will be somewhere between 5 and 10 feet from the Raspberry Pi.
Statistics: Posted by RHOPKINS13 — Tue Mar 05, 2024 12:05 am